Setup Functions; Automatic On/Off Function (Aut); On Or Off (Aut) - Spectral BRA2 Bedienungsanleitung

Setup functions

Automatic on/off function (AUT)

When this function is activated (ON) the device identifies a signal through the optical or coaxial input. When a signal is detected (e.g. by
switching on the source device) the sound system turns itself on. If no such signal is detected on the selected input (e.g. when the source
device has been switched off ) the sound system will automatically go into AUT standby mode after 30 seconds. When the function is deactivated
(OFF) the sound system needs to be switched on and off manually. The device is supplied with the function deactivated (OFF).
To enable/disable this function, follow these steps:
1 With the device switched on, press and hold the "Play Mode" key for more
than 3 seconds, until AUT appears on the display.
2 Press the "Volume +" key to activate the function (ON)
3 Press the "Volume –" key to deactivate the function (OFF).
4 Exit the menu by again pressing and holding the "Play Mode" key for more
than 3 seconds. If no input has appeared within 10 seconds the device will
automatically exit the configuration menu.
Note: The automatic switching on/off function only works for optical and coaxial
digital input. If the device is set to standby mode using the "ON/STANDBY" key on
the remote control it is not possible for the device to switch on automatically.
The device only identifies a signal via the selected digital input. A signal that
appears via anything other than the selected digital input will not be detected.
50
Downloaded from www.Manualslib.com manuals search engine
STEREO
STEREO BASS
SU RRO U N D
SURROUND TREBLE
Remote Control