Use; Unwind The Mains Cable; To Switch On And Off; To Regulate The Suction Power - Miele HS15 Gebrauchsanweisung

^ Take out the accessory you require.
^ Press down firmly on the lid to close
it.
Floorhead (dia. 17)
For general use and also for vacuuming
the stairs.
,
For safety reasons when
vacuuming stairs it is best to start at
the bottom of the stairs and move
upwards.

Use

Unwind the mains cable (dia. 18)
^ Pull the mains cable out to the
required length (max. cable length
approx. 7.5 m).
^ Insert the plug into the socket
correctly and switch on.
The Park system lighting on both sides
switches on.
The first time the vacuum cleaner is
used, the lighting switches on after
approx. 2 minutes.
,
If vacuuming for longer than
30 minutes, the mains cable must
be pulled out to its fullest extent.
Otherwise there is a danger of
overheating and damage.
To rewind the cable (dia. 19)
^ Switch off at the wall socket and
remove the plug.
Downloaded from www.Manualslib.com manuals search engine
After approx, 30 seconds the Park
system lighting switches off again.
^ Press the rewind foot switch briefly.
The cable will rewind automatically.
To switch on and off (dia. 20)
^ Press the On/Off foot control s.

To regulate the suction power

The suction power can be regulated to
suit the type of flooring being cleaned.
Reducing the suction power reduces
the amount of effort required to
manoeuvre the floorhead.
The vacuum cleaner has symbols on
the controls which indicate the type of
use the settings are suitable for.
The setting selected will light up yellow.
# - curtains, fabric
$ - upholstery, cushions
% - thick pile carpets, rugs and
runners
* - for energy-saving vacuuming
(this setting is also very quiet)
( - loop pile carpet
) - heavily soiled hard flooring
and intensive cleaning of carpets
When using the AirTeQ floorhead, if
the suction seems too high, reduce
the suction until the floorhead is
easier to manoeuvre.
Foot controls (dia. 21)
The first time the vacuum cleaner is
switched on, the highest setting will be
selected automatically.
en
37