Step 2: First Activation And Charging The Arm Module - Livassured NightWatch Bedienungsanleitung

5.2 Step 2: First activation and charging
the arm module
In principle, you only switch the arm
module on once, after which the arm
module is always on and can be charged.
From now on, you will start and stop the
system by connecting and disconnecting
the arm module and the charger.
EN
A
» Take a ballpoint pen/pencil
» The dark grey underside of the arm
72
NightWatch user manual v4.0 v3.indd 72 NightWatch user manual v4.0 v3.indd 72
A B
= Off B = On
module houses an on-off switch. Use
the pencil to move this switch to the
middle of the module to activate the
arm module. This only needs to be
done once. After this, you (de)activate
the system via the charging cable. If
you wish to turn the arm module off
to prevent the battery from running
out, use the on-off switch to turn off
the arm module. PLEASE NOTE: the
arm module will not charge if it is
turned off .
» As soon as you have activated the
arm module via the switch, 2 green
LEDs will light up brightly on the dark
underside. These are the LEDs that
measure the heart rate.
» Connect the arm module to the
charger and the power supply. The
arm module will now charge.
» Then connect the base station to the
power supply and wait until the arm
module is charged.
Arm module battery life:
» Battery charging time: approximately
2 hours.
» A fully charged battery will last at
least 12 hours.
Charging:
The arm module must be fully charged
before each use. When you connect the
arm module to the charger (which in
turn is connected to the power supply),
the green LEDs on the underside will
turn off and a green LED on the white
top part will start to blink. This indicates
that the arm module is charging. As
soon as the arm module is fully charged,
the green LED on the upper side will
be lit continuously. The LED on the arm
module emits dim rather than bright light
to minimise disturbance during the night.
PLEASE NOTE: Replace the product if a
fully charged battery is empty after a single
night or after one cycle of use.
PLEASE NOTE: Never let the battery run
down completely, as this will reduce the
battery capacity.
v4.0 NightWatch
15-07-20 16:12 15-07-20 16:12