Signals While The Arm Module Is Charging - Livassured NightWatch Bedienungsanleitung

» The wearer may be lying on the arm module, which would make registration diffi cult. Change
» The wearer's skin type might not be suitable to monitor a reliable heart rate. Change the
PLEASE NOTE: The alert "no/weak heartbeat signal" is meant to warn the user that due to the
unavailability of heartbeat data, temporarily, the NIghtWatch might not detect a potential epileptic
seizure as well. The alerts emitted by the NightWatch regarding the heart rate monitoring cannot be
used as a confi rmation of the quality or the existence of a heartbeat of the wearer.
PLEASE NOTE: The heart rate monitoring has been found to work less eff ectively on some very light or
very dark skins. If the arm module still often displays a "no or poor heart rate signal" after varying the
position and tightness of the armband, stop using the product and contact your supplier.
Out of range
There is no connection between the arm module and the base station. Several causes are possible:
EN
» The arm module is switched off . Turn on the arm module using a pen to move the on-off switch
» The arm module and the base station are too far apart. Place the base station and armband
» It may also be that only the arm module sends the light signal described above. In that case,
Low battery
This alert means that the arm module battery is nearly empty. You will no longer be able to use the
NightWatch. Connect the arm module to the charger.
If this alert appears repeatedly but you are sure that the arm module is continuously connected to
the charger during the day, please contact your supplier.
6.2

Signals while the arm module is charging

LED 4 lit continuously, LED 5 and A are blinking: Arm module is charging
The arm module is still charging. This will take up to 2 hours.
78
NightWatch user manual v4.0 v3.indd 78 NightWatch user manual v4.0 v3.indd 78
the position of the armband so that the wearer will not lie on top of it so easily.
position of the armband and tighten or loosen it as necessary.
on the dark underside. The green LEDs on the underside of the arm module should light up
when it is on and has been disconnected from the charger.
closer together.
check whether there is a power supply to the base station.
1 2 3 4 5 6
B
A
v4.0 NightWatch
15-07-20 16:12 15-07-20 16:12