Regulating The Sound On The Base Station - Livassured NightWatch Bedienungsanleitung

LED 5 and A are lit continuously: Arm module is charged.
1 2 3 4 5 6
The arm module is suffi ciently charged to use for a whole night.
6.3

Regulating the sound on the base station

Touch buttons A and B allow you to regulate the volume of the alerts emitted by the base station
or to temporarily stop an alert.
» Adjust the volume
Both buttons can be used to adjust the alert volume. Press down button 'A' or 'B'. You will
hear the epilepsy alert volume increase (A) or decrease (B). Release the button at the desired
volume. The volume is now set and will also be saved when you disconnect the base station
from the power supply. You can adjust the volume as you wish.
» Temporarily muting the sound
One of the buttons (it doesn't matter which one) can be pressed if you have heard an alert and
wish to turn it off . This is temporary. A subsequent alert will be audible again.
PLEASE NOTE: Ensure that the base station alert signal is set to an audible sound level during the entire
cycle of use.
PLEASE NOTE: Very loud sounds can trigger epileptic seizures in some people. Make sure that the signals
can be heard clearly by the person who needs to respond to them but are not too loud for the person
wearing the arm module.
NightWatch
NightWatch user manual v4.0 v3.indd 79 NightWatch user manual v4.0 v3.indd 79
B
1 2 3 4 5 6
A
B
A
v4.0
EN
79
15-07-20 16:12 15-07-20 16:12