Step 3: Using The Base Station; Daily Use - Livassured NightWatch Bedienungsanleitung

PLEASE NOTE: Always keep the arm
module connected to the charger until use
as it starts working automatically as soon
as it is removed from the charger. It is not
possible to 'overcharge' the arm module;
there is no harm in leaving the arm module
connected to the charger.
PLEASE NOTE: The arm module must only
be charged using the charger and cable.
Using a diff erent charger or cable could
damage the arm module and/or aff ect its
performance.
5.3

Step 3: Using the base station

Ensure that the (activated) arm module
is connected to the charger. Position the
base station where you want to receive
the alert and ensure it is connected to a
power supply.
The distance between the base station
and arm module is limited and depends
on the structure of the building in which
the NightWatch is used. It will usually be
15 metres. The base station will trigger
an alert if the arm module is or goes
out of range. If that happens, move the
base station closer to the arm module
or contact your supplier about the
possibility of increasing the range.
The volume of the base station alerts can
be adjusted as required using the volume
controls (see section 6.4)
NightWatch
NightWatch user manual v4.0 v3.indd 73 NightWatch user manual v4.0 v3.indd 73
1 2 3 4 5 6
B
After approximately 30 seconds, green
LED 4 on the base station will be lit
continuously ('arm module connected
to charger') and green LED 5 will start to
blink ('arm module battery is charging').
Once the arm module is fully charged,
green LED 5 will also be lit continuously.
Your system is now ready to use.
PLEASE NOTE: The base station should only
be connected to a power supply using the
adapter supplied. Using a diff erent adapter
could damage the base station and/or
aff ect its performance.
5.4

Daily use

» Roll up the wearer's pyjama sleeves, if
necessary.
» Disconnect the arm module from
the charger. Both green LEDs on the
darker underside of the arm module
will immediately light up brightly.
» Straight after disconnecting from the
charger, the base station will emit
a warning signal indicating that no
heart rate has been detected yet.
This signal also confi rms that the
arm module is connected to the base
station and that the alerts are audible.
» The red LED on the base station and
the armband will blink red to indicate
that no heart rate has been detected
yet.
v4.0
A
EN
73
15-07-20 16:12 15-07-20 16:12