Instructions For Use; Inserting/Replacing The Battery; Attach The Guard - WOLFF WS125 18.0V Originalbetriebsanleitug

Instructions for use

WARNING!
Remove the battery before carrying out any
work on the power tool.
Before switching on the power tool
Unpack the angle grinder and check that
there are no missing or damaged parts.
NOTE
The batteries are not fully charged on
delivery. Prior to initial operation, charge
the batteries fully. Refer to the charger
operating manual.

Inserting/replacing the battery

Press the charged battery into the power

tool until it clicks into place.
To remove, press the release button (1.)

and pull out the battery (2.).
CAUTION!
When the device is not in use, protect the
battery contacts. Loose metal parts may
short-circuit the contacts; explosion and fire
hazard!
20
Battery state of charge
Press the button to check the state of

charge at the state of charge indicator
LEDs.
The indicator goes out after 5 seconds.
If one of the LEDs flashes, the battery must
be recharged. If none of the LEDs light up
after the button is pressed, the battery is
faulty and must be replaced.

Attach the guard

WARNING!
When using the angle grinder for roughing
or cutting, never work without the guard.
A special cutting guard must be used for
cutting.
Remove the battery.

Attach the guard (1.). Lugs on the guard

hood must be located in the flange
recesses.
Turn guard hood clockwise (2.).

Rotation is possible in one direction
only!
Remove in reverse order.

WS125 18.0V