Find The Correct Viewing Channel; Select The Correct Tv System; Change System Menu Language; Turn On Progressive Scan - Philips mcd 712 Benutzerhandbuch

Find the correct viewing
channel
1
Press to turn on the unit.
2
Press DISC to switch to disc mode.
3
Turn on the TV and switch to the correct
video-in channel in one of the following
ways:
• Go to the lowest channel on your TV,
then press the Channel Down button
until you see the Philips screen.
• Press the source button repeatedly on
the remote control of your TV.
Tip
• The video-in channel is between the lowest
and highest channels and may be called
FRONT, A/V IN, VIDEO etc. See the TV user
manual on how to select the correct input on
the TV.

Select the correct TV system

Change this setting if the video does not appear
correctly. By default, this setting matches the
most common setting for TVs in your country.
1
Press SYSTEM MENU.
2
Select [Preference Page].
3
Select [TV Type] and then press
4
Select a setting and then press OK /
• [PAL] - For TV with PAL color
system.
• [Multi] - For TV that is compatible
with both PAL and NTSC.
• [NTSC] - For TV with NTSC color
system.
5
To exit the menu, press SYSTEM MENU.
16 EN
Change system menu
language
1
Press SYSTEM MENU.
2
Select [General Setup Page].
3
Select [OSD Language] and then press
.
4
Select a setting and then press OK /
5
To exit the menu, press SYSTEM MENU.

Turn on Progressive Scan

Progressive scan displays twice the number of
frames per seconds than interlaced scanning
(ordinary TV system). With nearly double the
number of lines, progressive scan offers higher
picture resolution and quality.
Before you turn on this feature, ensure that:
• The TV supports progressive scan signals.
• You have connected this unit with the TV
through component video.
1
Turn on the TV.
2
Ensure that the TV progressive scan
mode is deactivated (see the TV user
manual).
3
Switch the TV to the correct viewing
channel for this unit.
4
Press DISC.
.
5
Press SYSTEM MENU.
.
6
Press
in the menu, then press .
7
Select [Component] > [Pr/Cr Pb/Cb Y],
then press OK /
8
Select [TV Mode] > [Progressive], then
press OK /
»
9
To proceed, select [Ok] and press OK /
»
/ to select [Video Setup Page]
.
.
A warning message is displayed.
.
The progressive setup is complete.
.