Get Started; Prepare The Remote Control; Set Clock; Turn On - Philips mcd 712 Benutzerhandbuch

4 Get started

Caution
• Use of controls or adjustments or
performance of procedures other than herein
may result in hazardous radiation exposure or
other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
bottom of the apparatus. Write the numbers
here:
Model No. __________________________
Serial No. ___________________________

Prepare the remote control

Caution
•
Risk of explosion! Keep batteries away from
heat, sunshine or fi re. Never discard batteries
in fi re.
For fi rst-time use:
1
Remove the protective tab to activate the
remote control battery.
To replace the remote control batteries:
1
Open the battery compartment.
2
Insert one lithium CR2025 battery with
correct polarity (+/-) as indicated.
3
Close the battery compartment.
Note
•
Before you press any function button on the
remote control, fi rst select the correct source
with the remote control.

Set clock

1
In the Eco Power standby mode, press
and hold CLOCK to activate the clock
setting mode.
»
The hour digits are displayed and begin
to blink.
2
Press + VOL - to set the hour, then press
CLOCK again..
»
The minute digits are displayed and
begin to blink.
3
Press + VOL - to set the minute.
4
Press CLOCK to confi rm the clock
setting.

Turn on

1
Press .
»
The unit switches to the last selected
source.
Switch to Eco Power standby mode
1
Press to switch the unit to Eco Power
Standby mode.
»
The backlight on the display panel
turns off.
»
The blue Eco Power indicator turns on.
Tip
•
In the Eco Power mode, you can press
CLOCK to switch to the standby mode and
view the clock (if set).
•
If the system remains in the standby mode for
more than 90 seconds, it switches to the Eco
Power mode automatically.
EN 15