T+A CRITERION TCI C 2 Betriebsanleitung Seite 26

Trouble-shooting
Many problems
correspondingly simple solution. The following section
describes a few difficulties you may encounter, and the
measures you need to take to cure them.
If you find it impossible to solve a problem with the help
of these notes please ask your authorised  specialist
dealer for advice.
Problem:
Cause:
Remedy:
Problem:
Cause:
Remedy:
Problem:
Cause:
Remedy:
Cause:
Remedy:
Problem:
Cause:
Remedy:
Downloaded from www.Manualslib.com
have a simple cause
No output signal, or seriously distorted
signal at the loudspeakers.
Short-circuit at the loudspeaker cables;
e.g. through stray wire strands at the
terminal clamps, or mechanical damage to
the cables.
Check loudspeaker cables and terminals
carefully, twist wire ends neatly (conductor
sleeves can also be used); be sure to
replace damaged cables!
Flat sound image, insufficient bass
response.
The loudspeaker cables are connected
with reversed polarity.
Check the speaker connections at the
loudspeakers and at the
speaker terminals, referring to the wiring
diagram; correct if necessary.
Excessive or booming bass response.
The loudspeaker is set up too close to the
wall or in one corner of the room.
Maintain a minimum distance of 50 cm to
the side walls, or change the setting of the
' '
BASS switch on the back of the speaker.
Sympathetic vibration of floor, room walls
or furniture.
Use spikes or damping elements to suit
your installation. Ask your specialist 
dealer for advice.
No treble response from the TCI C2.
The high voltage for the electrostatic treble
units is not present.
Check the mains supply.
manuals search engine
and a
amplifier's
26