Geutebruck GSD-682 Installationsanleitung Seite 123

• PRESET POINT
Select a preset point where the dome should go when an alarm pin is triggered.
The preset point(s) should be set prior either in the PRESET setup menu or via
joystick.
SEQUENCE LINE
Select a sequence line that the dome camera should execute when an alarm pin
is triggered. The sequence line(s) should be defined prior either in the
SEQUENCE setup menu or via joystick.
AUTOPAN LINE
Select an autopan line that the Dome Camera should execute when an alarm pin
is triggered. The autopan line(s) should be defined prior either in the AUTOPAN
setup menu or via joystick.
CRUISE LINE
Select a cruise line that the Dome Camera should execute when an alarm pin is
triggered. The cruise line(s) should be defined prior either in the CRUISE setup
menu or via joystick.
• DWELL TIME
DWELL TIME means the duration of executing an alarm action. If the PRESET
mode is selected, the dome camera wiII go to the selected preset position and
stay there for a user-defined period of time (1~127seconds/always) when alarm
takes place. If other modes (SEQUENCE/AUTOPAN/CRUISE) have been
selected, the camera wiII keep executing the selected mode (DWELL TIME:
ALWAYS) until alarm condition is released or users rotate the joystick to change
the status of the dome camera.
Downloaded from www.Manualslib.com
NOTE: The dwell time is only adjustable when selecting Preset for alarm
action. When the dwell time is up, the dome camera wilI go back to its trigger
position and recheck alarm pin status.
manuals search engine
57