Pioneer DRM-7000 Bedienungsanleitung Seite 21

Whenever a disc magazine is inserted into the changer,
its ID will be automatically read in and displayed on the
LCD message window within a few seconds.
A similar message will also be displayed whenever a disc
magazine has been removed.
If both of these messages appear together in rapid
succession, it indicates that a disc magazine has not been
correctly inserted, and you should check the magazine to
make sure that it has been inserted properly again.
2. Insert discs into a 20-disc hyper magazine and insert
the magazine into the changer.
1 Turn the release knob to the vertical direction to unlock.
2 Insert discs.
3 Turn the release knob to the horizontal direction to lock
the discs into place.
Label
NOTES:
¶ Insert with label facing upward.
¶ Insert discs horizontally. Otherwise it may result in
damage to the discs.
¶ Be careful not to scratch the reflective signal recording
surface.
¶ Do not turn a disc magazine upside down while the
lock is disengaged. Otherwise it may result in discs
falling out of the magazine.
Release knob
Lock release Lock
4 Insert magazine into changer.
Once the hyper magazine has been inserted partly into
the changer, it will be automatically loaded in.
When the hyper magazine has been loaded, a unique
magazine ID will be displayed together with the record of
the locking mechanism.
Note that the magazine will be automatically ejected if the
changer is unable to read the magazine ID, and that if this
happens you should try inserting the magazine again.
NOTE:
If hyper magazine has been installed, see the instructions
given in System administrator mode: Hyper submode (p. 35)
removing the hyper magazine.
Installation
LO
C K
U N
LO
C K
P O
W E
R
R O
B O
T IC
B U
S Y S
D R
IV E
B U
S Y M A
IL
O C S L
C U O T
P IE
D
≠
21
<DRC1184>
En