Pioneer DRM-7000 Bedienungsanleitung Seite 19

SCSI Cable Connection Example:
¶ Install 2 internal drives within the changer in a daisy-chain
configuration and connect the drives to the changer.
Total length of SCSI cables: approx. 2.1m
(Note that this does not include the length of the cable
running from the host computer to the changer.)
Rear of changer
Rear plate
Connector panel
Cable
Host
Host computer
¶ Install 6 internal drives within the changer in a daisy-chain
configuration and connect the drives to the changer.
(Additional cable for 4 drives will be needed.)
Total length of SCSI cables: approx. 2.9m
(Note that this does not include the length of the cable
running from the host computer to the changer.)
Cable for
4 drives
Host
Terminator ON
Drive 2
Drive 1
Changer board
Terminator ON
Drive 6
Drive 5
Drive 4
Drive 3
Drive 2
Drive 1
¶ Install 4 internal drives within the changer in a daisy-chain
configuration and connect the drives to the changer.
(Additional cable for 2 drives will be needed.)
Total length of SCSI cables: approx. 2.5m
(Note that this does not include the length of the cable
running from the host computer to the changer.)
Cable for
2 drives
Host
¶ Connect 4 drives directly to the individual host adapters.
(Additional four single drive connector panels will be
needed and pre-attached multi drive connector panel may
be removed.)
Single drive
connector panel
Host
Host
Host
Host
Host
Installation
Terminator ON
Drive 4
Drive 3
Drive 2
Drive 1
Drive 4
Drive 3
Drive 2
Drive 1
19
<DRC1184>
En