Functional Description; Parts Description - Makita DUC204 Betriebsanleitung

2. Never recharge a fully charged battery
cartridge. Overcharging shortens the battery
FUNCTIONAL
DESCRIPTION
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before adjusting or checking function on the tool.
Installing or removing battery
cartridge

PARTS DESCRIPTION

►
Fig.2
1 Switch trigger
4 Front hand guard
7 Chain catcher
10 Chip guide
13 Main power switch
16 Front handle
CAUTION:
Always switch off the tool before
installing or removing of the battery cartridge.
CAUTION:
Hold the tool and the battery
cartridge firmly when installing or removing
battery cartridge. Failure to hold the tool and the
battery cartridge
them
your
damage to the tool and battery cartridge and a
personal
►
Fig.3: 1. Red indicator 2. Button 3. Battery
cartridge
To remove the
slide it
tool while sliding the button on the
front of the cartridge.
To install the
align the tongue
battery cartridge with the groove in the housing and slip
it into place. Insert it all the way until it locks in place
2 Top
5 Guide bar
8 Retaining nut
11 Battery cartridge
14 Adjusting
17 Oil tank cap
firmly may cause
to slip off
hands and result in
injury.
battery cartridge,
from the
battery cartridge,
on the
with a little click. If you can see the red indicator on the
upper side of the button, it is not locked completely.
CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen. If not, it
may
out
causing
someone around you.
CAUTION:
Do not install the battery cartridge
forcibly. If the cartridge does not slide in easily, it is
not being inserted correctly.
Indicating the remaining battery
service life.
3. Charge the battery cartridge with room
temperature at 10 °C - 40 °C (50 °F - 104 °F).
Let a hot battery cartridge cool down before
charging it.
4. Charge the battery cartridge if you do not use
it for a long period (more than six months).
handle
screw (for
oil pump)
capacity
Only for battery cartridges with the indicator
►
Fig.4:
button
Press the check button on the battery cartridge to
indicate the
The indicator
seconds.
18 ENGLISH
accidentally
of the
injury to
3 Lock-off lever
6 Saw chain
9 Chain adjusting
12 Main power lamp
15 Carabiner
18 Guide bar cover
1. Indicator lamps 2. Check
remaining battery
lamps light up for a few
fall
tool,
you or
screw
capacity.