Automatic Screen Adjustment; Adjusting The Backlight - Sharp LL-T1810A Bedienungsanleitung

Automatic screen adjustment

Options in MENU 1 (ADJUSTMENT) can be ad-
justed automatically (CLOCK, PHASE, H-POS, V-
POS).
Note:
- When setting up the monitor or a connected
computer for the first time, connecting an
additional computer or after having changed an
aspect of the current system, perform an
automatic screen adjustment before use
Automatic adjustment screen display
To perform an automatic adjustment, first display an
image that makes the entire screen very bright. If
you are using Windows, you can also use the
Adjustment Pattern on the accompanying Monitor
Settings Adjustment Disk for Windows.
Displaying the Adjustment Pattern (for Windows)
This explanation is for Windows 95/98/2000, and
assumes that the floppy disk drive is [A drive].
Note:
- If the floppy disk drive of your computer is not
"A drive", please read the below substituting the
floppy disk drive you are using in place of
"A drive" or "A".
1. Place the Monitor Settings Adjustment Disk
(provided) into the computer's A drive.
2. Open [My Computer] and select [3 ½ Floppy
(A:)]. If using Windows 3.1, open [File Manager]
and choose "A drive".
3. Double click on [Adj_uty.exe] to run the
Adjustment Program. The Adjustment Pattern will
appear.
Notes:
- After completing the adjustment, press the
computer's [Esc] key to exit the Adjustment
Program.
- If your computer's display mode is set to 65K
colors, you may see the different color levels in
each color pattern or the gray scale may look
colored. (This is due to the input signal
specification and is not a malfunction.)
Downloaded from: http://www.usersmanualguide.com/
Adjusting the screen display
Adjustment pattern
Adjusting the screen automatically
1. Press the MENU button.
The ADJUSTMENT Menu will be displayed.
2. Press the button.
The screen will become dark and [ADJUSTING]
will be displayed. After a few seconds the
ADJUSTMENT Menu will return. (The automatic
adjustment is now complete.)
3. Press the MENU button 4 times to make the On
Screen Display (OSD) Menu disappear.
Notes:
- In most cases the monitor is ready to be used
after automatic adjustment.
- If necessary due to any of the following, manual
adjustments (p. 19) can be made after the
automatic adjustment.
- When further fine adjustment is needed.
- When the computer's video input signals are
Composite Sync or Sync On Green.
(Automatic adjustments may not be
possible.)
- When, after command 2 above, [OUT OF
ADJUST] is displayed. (When the screen
displays an entirely dark image, the
automatic screen adjustment may be
disabled. When making an automatic
adjustment, be sure to either use the
Adjustment Pattern or try displaying an image
that makes the entire screen very bright.)

Adjusting the backlight

The backlight brightness can be adjusted.
Carry out the commands without the On Screen
Display (OSD) Menu displayed. If the OSD Menu is
displayed, press the MENU button (several times
may be required) and begin when the OSD Menu
has disappeared.
1. Without the OSD Menu being displayed, push the
or the button. At the bottom of the screen the
BRIGHT bar will appear.
2. Adjust by pressing the
button (lighter).
The BRIGHT bar automatically disappears approxi-
mately 3 seconds after the last command.
18
button (darker) or