Makita LXT DTD171 Betriebsanleitung Seite 11

Application mode
(Assist type displayed
on panel)
T mode (1) *1
T mode (2) *1
*1 : Automatic speed control works only when the switch trigger is fully pulled.
*2 : Reverse rotation auto stop works only when the tool is driving in counterclockwise rotation.
NOTE: When none of the lamp on the panel is lit, pull the switch trigger once before pressing the button
NOTE: All lamps on the switch panel go out when the tool is turned off to save the battery power. The type of the
application mode can be checked by pulling the switch trigger to the extent that the tool does not operate.
Quick mode-switching function
What you can do with the quick mode-
switching function
The quick mode-switching function saves the time
for changing the application mode of the tool. You
can switch to your desired application mode by just
pressing the quick mode-switching button. It is helpful
when doing a repetitive work which requires to switch
between two application modes alternately.
EXAMPLE If you have a work to use T mode and
max impact force, register the max impact force for
quick mode-switching function. Once register it, you
can switch to the max impact force from T mode by
just one click of the quick mode-switching button.
Also, you can return to T mode by pressing the quick
mode-switching button again.
Even if the tool is in other application mode than T
mode, pressing the quick mode-switching button
changes to max impact force. It is convenient for you
to register a application mode that you frequently use.
You can choose one of following application modes for
quick mode-switching function:
Impact force
• Max
• Hard
• Medium
• Soft
Assist type
• Wood mode
• Bolt mode
• T mode (1)
• T mode (2)
Maximum blows
– This mode helps to prevent the screws from
(The tool stops rotating over-tightening. It also accomplishes quick oper-
soon after impact starts.) ation and good finish at the same time. The tool
drives a screw with high-speed rotation and stops
soon after the tool starts to impact.
NOTE:
The timing to stop the driving varies depending
on the type of the screw and material to be
driven. Make a test driving before using this
mode.
-1
2,600 min (/min) This mode helps to prevent the screws from
breakage and stripping. It also accomplishes quick
operation and good finish at the same time. The tool
drives a screw with high-speed rotation and slows
down the rotation when the tool starts to impact.
NOTE:
Release the switch trigger as soon as the tight-
ening finished to avoid overtightening.
Feature
Registering application mode
To use the quick mode-switching function, register your
desired application mode to the tool beforehand.
1. With the button
application mode.
2.
Press and hold the button
mode-switching button at the same time until the cus-
tomize lamp and the lamp of desired application mode
blinks.
► Fig.11: 1. Quick mode-switching button
2. Customize lamp
NOTE: You can overwrite the current application
mode with new one by performing the procedure
above.
Using the quick mode-switching function
When the tool is in the mode that is not registered,
press the quick mode-switching button to switch to the
registered application mode. The tool switches between
the registered application mode and last application
mode every time you press the quick mode-switching
button. The front lamps on both sides will flash once
when switching to the registered application mode.
NOTE: The customize lamp will light up when the
application mode registered to the tool is chose.
Cancelling the quick mode-switching
function
Press and hold the button
ing button at the same time until the customize lamp
and all impact force grade lamps blink.
NOTE: After cancelling the quick mode-switching
function, the quick mode-switching button works for
changing the impact force.
11 ENGLISH
Purpose
Driving self-drilling
screws to a thin metal
plate with good finish.
Driving self-drilling
screws to a thick metal
plate with good finish.
.
or , choose your desired
and the quick
and quick mode-switch-