Using The Headphones; Charging The Headphones; Using The Headphones With The 2.4 Ghz Transmitter; Using The Headphones With An Audio Cable - Medion ERAZER Mage X10 Bedienungsanleitung

6. Using the headphones

6.1. Charging the headphones

 Use the USB cable supplied to connect the headphones to the USB power sup-
ply.
As soon as the headphones are connected to a power source, the built-in recharge-
able battery begins charging automatically and the charging LED lights up.
The battery charging time is about 3 hours.
6.2. Using the headphones with the 2.4 Ghz
transmitter
 Connect the microphone to the corresponding port on the headphones.
 Connect the supplied USB transmitter to a free USB port on your PC or laptop.
 Press and hold the On/Off button for approximately 3 seconds.
The headphones switch on and automatically connect to the 2.4 GHz transmitter.
 Set the required volume level.
 You may need to push the microphone closer to your mouth if other call partici-
pants are finding it difficult to hear you.

6.3. Using the headphones with an audio cable

 Connect the microphone to the corresponding port on the headphones.
 Connect the end with the remote control unit of the audio cable to the head-
phones.
 Now connect the audio cable to the corresponding port on your PC or laptop.
 Press and hold the On/Off button for approximately 3 seconds.
 Set the required volume level.
 You may need to push the microphone closer to your mouth if other call partici-
pants are finding it difficult to hear you.
Use the sound card microphone amplification or conference call soft-
ware to increase the microphone recording level.
24