JUNO JB071B1 Benutzerinformation Seite 22

22
How to remove: Shelf supports
Remove the shelf supports to clean the
oven.
Step 1 Turn off the oven and wait un‐
til it is cold.
Step 2 Pull the front of the shelf sup‐
port away from the side wall.
Step 3 Pull the rear end of the shelf
support away from the side
wall and remove it.
Step 4 Install the shelf supports in
the opposite sequence.
How to remove and install: Door
The oven door has two glass panels. You can remove the oven door and the internal
glass panel to clean it. Read the whole "Removing and installing door" instruction before
you remove the glass panels.
CAUTION! Do not use the oven without the glass panels.
Step 1 Open the door fully and hold
both hinges.
Step 3 Close the oven door halfway
to the first opening position.
Then lift and pull forward and
remove the door from its seat.
1
Step 2 Lift and turn the levers fully on
both hinges.
Step 4 Put the door on a soft cloth on
a stable surface and release
the locking system to remove
the internal glass panel.
2