GUTMANN VIENTO Montageanleitung Seite 22

EN
Assembly preparation / Worktop / Kitchen furniture
Installation, important notes !
• Avoid excessive heat generation from below, e.g. from a baking oven without cross-flow
fan.
• The induction hob must not be used when pyrolysis operation takes place on built-in coo-
kers.
• When installing above a drawer, care must be taken to ensure that no sharp objects are
stored in the drawer. These could tilt on the underside of the hob and block the drawer.
Ensure that the cooktop inductors are adequately ventilated.
• The cooktop must not be installed above refrigerators, dishwashers, washing machines
or dryers.
• It must be ensured that no flammable, easily ignitable or heat deformable objects are
placed directly next to or below the hob due to the risk of fire.
Hob gasket
Wood worktops must be sealed on the cut surfaces. Before installation, the enclosed cook-
top gasket must be inserted without gaps.
• It must be prevented that liquids can penetrate between the edge of the hob and the
worktop or between the worktop and the wall into any electrical appliances installed un-
derneath.
• If the hob is installed in an uneven worktop, e.g. with a ceramic or similar covering (tiles,
etc.), the sealing must be carried out with level compensation of the cooking surface
against the worktop using plastic sealing materials (e.g. Novasil® or Ottoseal® ).
Note: If sealing adhesive is used for sealing and fixing, a later, non-destructive removal of
the hob cannot be guaranteed.
Worktop cut-out
The cut-out in the worktop should be made as accurately as possible with a good, straight
saw blade or a router. The cut surfaces should then be sealed to prevent moisture from pe-
netrating. The cut-out for the hob is made according to the illustrations. The glass-ceramic
hob surface must be flat and flush. Tensioning can cause the glass plate to break. Check
the seal of the cooking surface for a perfect fit and complete support.
PU sealing tape 3x10mm at the mount bearing surfaces all around. Flush mounting also
possible in the countersink. Consider the height of the glass plate. Level adjustment if re-
quired.
22