Fire Safety - Kirami CUBE Gebrauchsanweisungen

© Kirami Oy, Finland
If the heater is located near buildings, for example on the side of a terrace, the distance of the chimney
from any combustible materials must be
adequate. Remember to check the distance
both laterally and vertically so that there isn't
any risk of fire. Local rules may vary.
Notice also the fire safety in front of the
furnace. There shouldn't be any combustible
materials in front of the furnace. There should
be an area, which is demonstrated in the
picture that should be made of incombustible
material such as concrete, sand or metal.
Grates
A fire grate is installed to the heater, with two
grill plates. The heater must not be used without these parts. Note that these parts wear
down over time and get bent and their form will change in use. You can purchase new
ones as spare parts when needed.
Chimney
You can use a Ø150mm outer diameter acid-proof chimney with this heater. The reduced
end of the chimney fits inside the heater. The chimney parts can be purchased separately in three
different lengths: 25 cm, 50 cm and 100 cm. There are also available adjustable chimney corners and
100 cm long protective sleeves for the lower part of the chimney.
We recommend a chimney kit for the heater. This package includes 200
cm chimney + 100cm protective sleeve and a standard hat. There are
also spark protective hats available for the chimney.
If you have purchased a chimney kit with the heater. It is supplied in a
separate box and has four parts (see picture right) and it has to be
assembled.
Remove the protective film from the thermal protection and place the
assembled chimney to the chimney outlet of the stove.
Be careful, the edges of the chimney are very sharp. Use protective gloves!
Magnesium anode rod
Magnesium will work as anode, meaning that magnesium will corrode before
heater's aluminium does.
The mangesium rod should be replaced annually or after it has been depleted. If the
rod hasn't been changed on time the heater won't have guarantee left.
Replacement instructions are on the replacement rod package.
NB! Before heating up check that the thread is waterproof. If water is leaking
through the thread then fasten it more and check that o-ring is in place.
User manual: Kirami CUBE Hot tub heater
18/52

FIRE SAFETY

Page 4
18.05.2020