Kirami CUBE Gebrauchsanweisungen Seite 17

© Kirami Oy, Finland
Installation for Original Woody tubs
Kirami wooden tubs have Ø75mm connection pipe pieces and preinstalled holes
with bolts and nuts to fix the connection plates delivered with the tub.
1) Install the delivered plates and leave them loose, it makes the insertion of
the heater easier.
2) The heater is pushed into its place so that the tub pipes go inside the
hoses on the heater. And the heater remains in horizontal position.
3) Tighten the hose clamps form both ends. And the tub plates.
4) Use the supplier self-drilling screws to fix the heater to the tub's
plates. The screws are meant to drill through the wooden panel, the
tub plates and the heater plates. There should be three screws on
each side of the heater. Four top ones make the actual fixing and the
Installation for Original Easy, Comfort Cozy/Steady
and Premium Classy/Pearly tubs
The plastic Easy and Cozy hot tubs do not have connection plates.
So the heater is connected just with the hoses and clamps just like
Woody installation points 2) and 3). If you have purchased a Macu
drink holder or version of the hot tub with covering side plates
those can be attached with included screws to the heater plates.
With plastic hot tubs the heater must have some supports
underneath so that it will not hang from the hoses.
Installation further away from the tub
The standard heater should not be installed further away from the
tub. If you are planning installation further away from the tub you should purchase an extension tube
set with intermediate pipes, extra clamps and rubber hoses. When installing further away the heater
must be a bit lower than the tub so that the natural circulation of heated water works
Note that a heater that is installed lower will not empty properly which may cause a risk of freezing in
winter. In case the heater installed further away, the heater must have supports underneath.
User manual: Kirami CUBE Hot tub heater
17/52
two lower ones fix the panel so that it stays in
nice vertical position. If a drink holder / panels
is not installed the only two screws are used
on both sides.
The heater will be hanging on the wall of the tub by the hoses ad plates
Page 3
18.05.2020