Fire Safety - Kirami CUBE Gebrauchsanweisung

EN
CUBE outside hot tub heater- Instruction manual Page 18/52

Fire safety

If the heater is located near buildings, for example
on the side of a terrace, the distance of the chimney
from any combustible materials must be adequate.
Remember to check the distance both laterally and
vertically so that there isn't any risk of fire. Safe
minimum distance, from the chimney's upper end,
laterally is three (3) meters. Shorter distance
laterally is adequate in other parts of the chimney. If
the chimney is closer to any combustible materials
you must use special insulated chimney, which has
to be purchased separately.
When positioned close to the roof or when taken through it, the top end of the insulated
chimney must be at least one (1) meter above the surface of the roof. Ask your local fire
officer for more information.
Notice also the fire safety in front of the furnace. There shouldn't be any combustible
materials in front of the furnace. There should be an area, which is demonstrated in the
picture that should be made of incombustible material such as concrete, sand or metal.
Grates
For the CUBE heater, two cast iron grates and one
L-shaped iron plate will be delivered. Those are to
be positioned on the tracks in the heater. The order
of the grates is shown on the right side. L-shaped
iron plate is to be installed bended edge upwards. It
will deflect the air and also prevent the firewood to
drop out from the heater.
Chimney
You can use a Ø150mm outer diameter acid-proof chimney with this heater. The reduced
end of the chimney fits inside the heater. The chimney parts can be purchased separately in
three different lengths: 20 cm, 50 cm and 100 cm. There are also available adjustable
chimney corners and 100 cm long protective sleeves for the lower part of the chimney.
We recommend a chimney kit for the heater. This package includes 200 cm chimney +
100cm protective sleeve and a standard hat. There are also spark protective hats available
for the chimney.
If you have purchased a chimney kit with the heater. It is
supplied in a separate box and has four parts (see picture
right) and it has to be assembled.
Remove the protective film from the thermal protection and
place the assembled chimney to the chimney outlet of the
stove.
Be careful, the edges of the chimney are very sharp.
Use protective gloves!
Updated 08/2013