Troubleshooting - Klarstein Trifecta 4 Bedienungsanleitung

EN
32

TROUBLESHOOTING

Problem
Ignition electrode
does not catch fire
When the knob is
released, the flame is
extinguished.
Pulse igniting, but fail
or igniting difficultly
Cause
No battery, installation of
battery is bad contact or
reversed
The burner is not installed
in place
Improper position of
ignition electrode and
inner fire cover
Ignition electrode is damp
or dirty due to food
spillage
The pressing pressure is
not enough, the safety
solenoid valve is not
sucking.
Gas valve is not open or
not fully open
There is air in the gas pipe
Burner, burner cap, etc.
are not installed correctly
The fire hole is blocked on
the burner cap and the
gas cannot flow normally.
Ignition electrode is damp
or dirty due to food
spillage
Gas connection pipe is
flattened and blocked
Battery energy is not
enough
Treatment
Reinstall correctly
Reinstall correctly
Adjust the distance
between the ignition
electrode and the inner
fire cover to 3-4mm
Dry the ignition electrode
with a dry soft cloth
Re-ignite and press the
knob in place before you
can let go.
Confirm that the gas valve
is fully open
Repeated ignition
operation until succeed
Reinstall correctly
Unblock and clean the dirt
in the fire hole
Dry the ignition electrode
and remove dirt
Adjust or replace the gas
connection tube
Replace battery
Reinstall correctly