Bin Settings, Loading, And Label Creation; Changing The Bin Configuration; Loading Discs; Refreshing Bin Levels - Rimage Professional 2450 Benutzerhandbuch

Bin Settings, Loading, and Label Creation

8.1: Changing the Bin Configuration

Through the Rimage Software Suite, you may specify a media type for
each media bin and designate bins as Input, Output, Reject, Reserved,
Collate, or Unused.
1. Double-click on the Rimage System Manager shortcut on your desktop.
2. Click on the Configure Bins... button within the Media section of Rimage
System Manager.
3. If only using one Media Type (CD/DVD/Blu-ray), choose that Media Type
and configure the bin designations as desired.
4. If using multiple media types, choose Combination as the Media Type
and configure the bin designations as needed.
5. Click on OK.
Tip: Changing the bins may change the picking configuration. For
example, if bin 2 is configured for input DVDs, a DVD job will pull
directly from bin 2 instead of the system default of bin 1. The
competed DVD will then be deposited into the chosen output bin, or,
if not successfully completed, to the bin selected for rejects.

8.2: Loading Discs

You can load up to 50 discs in each input bin. Use the procedure below to
load discs in each bin.
1. Open the front door.
2. Press the rotate carousel button as needed to rotate the carousel to
the desired bin.
Add required type and number of discs, placing them so the
3.
recording surface is face down.
4. Repeat steps 2 - 3 until the required bins are filled.
5. Close the front door.
2004849_A

8.3: Refreshing Bin Levels

Selecting Refresh Bins resynchronizes the quantities of media in each bin
so that it shows correctly on the control panel display and in Rimage
System Manager. This should be done after adding media to one or more
bins after startup. Because the system cannot register the updated
quantities until the lift arm determines the new amount, the display will
show "?? ?? ??" as the bin qualities until the levels have been refreshed.
1. To refresh bin levels, double-click on the Rimage System Manager
2. Click the Refresh Bins... button within the Media section of
3. Click OK.
Important: If, after following the Refreshing Bin Level instructions, the
lift arm has not recounted the media, you will need to manually
rotate the disc carousel at least one quarter turn in either direction
and repeat steps 2 and 3 above.

8.4: New Label Creation

1. Double-click the CD Designer shortcut on your desktop.
2. Click on Start a new CD Designer document...
3. Choose Blank Template and click on Next.
4. Retain the Default printer setting and click Next.
5. Choose Full Surface or Standard, depending on your needs and disc
6. Select from the following Background Features:
For more information visit rimage.com/support
shortcut on your desktop.
Rimage System Manager.
type, and click Next.
• Color: This allows you to use a fill color as your background
• Picture: This allows you to use an image as your background
• Template Image: This allows you to use a set image of a
completed design and manipulate images and text in the
foreground to conform to that set image.
8