Status Light And Control Panel; Status Light; Control Panel - Rimage Professional 2450 Benutzerhandbuch

Status Light and Control Panel

6.1: Status Light

The Professional 2450 is equipped with a built-in status light that indicates
various conditions. The table below illustrates status light states and
explains the conditions indicated by each state.
Light State System Condition
Green light The system is operating properly. No jobs are currently
on processing.
Green light The system is operating properly. Jobs are currently
blinking processing.
Yellow The autoloader is waiting for the software to start. If
light on the control center is not started, power on the control
center. Check the cable connections on the autoloader
and control center.
The front door is open. Close the front door to allow
Yellow
light jobs to process.
blinking
A red light could indicate several issues. The most
Red light
common are as follows:
on
• The carousel is out of blank discs.
• A system error requires operator intervention.
• An error with the printer or recorders occurred
at initial startup.
To help determine these and other red light system
conditions, check the client workstation or control
center for a message.
2004849_A

6.2: Control Panel

The control panel is located on the front of
the 2450. It includes the operator panel,
the rotate carousel button (button 1), and the printer tray button
(button 2). The table below identifies the name and function of all parts of
the control panel.
Important: You must open the front door of the autoloader to access
the control panel.
Name
Operator
panel
Rotate carousel
button (button 1)
Printer tray button
(button 2)
Printer indicator
light (on the printer
tray button)
Rotate carousel
indicator light (on
the rotate carousel
button)
For more information visit rimage.com/support
Function
The operator panel has a two-line display that informs
you of operations or conditions that require operator
intervention. This includes the consumable status.
Refer to the Display Name and Beeper Settings section
on page 10 to see other options for configuration.
Press the rotate carousel button to:
• Rotate the carousel and position a bin to load and
unload discs. Each time you press the rotate carousel
button, the carousel rotates to the next bin.
• Enter diagnostic test mode. Refer to the Diagnostic Test
Instructions on the documentation disc that shipped
with your system.
Press the printer tray button to:
• Open and close the printer tray
• Reset after an error
The printer indicator light illuminates when the printer
is powered on and has completed initialization. The
printer indicator light also flashes when the Everest 400
printer is receiving data from the host.
The rotate carousel indicator light illuminates when
you rotate the carousel. The rotate carousel indicator
light also flashes when the autoloader is receiving data
from the host.
6