Maintaining The 2450; Importance Of Maintenance; Cautionary Information; Preventative Maintenance Schedule - Rimage Professional 2450 Benutzerhandbuch

Maintaining the 2450

This section provides maintenance information for the 2450 system,
including the integrated Everest 400 printer.
Important: For optimum performance, keep the 2450 in a clean, dust-
free environment.

13.1: Importance of Maintenance

Regular preventative maintenance of your system can help to ensure error-
free recordings and clean printed labels. Maintenance involves cleaning the
system.

Cautionary Information

Caution: To avoid damaging the 2450 during maintenance:
n
• Never use oils, silicone, or other lubricants on any part of the system.
• Use only non-abrasive cleaners to wipe down the surfaces of your
system.
• Avoid pouring cleaners directly onto the autoloader. Instead, apply
the cleaner on a clean, lint-free cloth.

13.2: Preventative Maintenance Schedule

The following is a table of maintenance tasks, the tool required to
complete them, and their required frequency.
2004849_A
Task
Autoloader Maintenance
Wipe down the lift arm shaft. Pay close
attention to:
• The base of the shaft
• The area just above the lift arm
Wipe down all surfaces of the
autoloader including:
• Sides and top
• Door
• Output bin
• Carousel
• Base (remove the carousel first)
• Top surface on the lift arm
Inspect air filter on the side of
the system and replace if necessary.
Inspect the openings at the back of the
autoloader. Remove dust and debris if
necessary.
Remove the carousel and remove dust
and debris from the openings.
Integrated Everest 400 Printer Maintenance
Clean the tacky rollers. Refer to the
Cleaning the Tacky Rollers and Sensors
section on page 14.
Clean the sensors. Refer to the
Cleaning the Tacky Rollers and Sensors
section on page 14.
For more information visit rimage.com/support
Tools Frequency
Lint-free Weekly
cloth
Lint-free Weekly
cloth
Non
-
abrasive ,
all-purpose
cleaner
N/A Monthly
Vacuum Monthly
• Sponge swabs
After 2000 discs
(included in the
or at every ribbon
Everest cleaning
change
kit)
• 99% Isopropyl
alcohol
If the print ribbon
• Sponge swabs
is not detected,
(included in the
the upper or
Everest
lower sensor is
cleaning kit)
not responding, or
• 99% Isopropyl
the label is off
alcohol
center
13