Tacky Roller Cleaning (Continued); Cleaning Tacky Roller - Rimage Professional 2450 Benutzerhandbuch

Tacky Roller Cleaning (Continued)

15.1: Cleaning Tacky Roller 2

Important: Please follow steps 1 and 2 on page 14 to prepare the
tacky roller 2 for cleaning if you have not done so already.
1. Remove tacky roller 2:
a. Turn the thumbscrew counterclockwise three complete rotations.
b. Push the end piece outward and to the left until it is free from
the center bracket.
c. Grip the end piece and pull the entire tacky roller 2 out of the
printer.
End Piece
Clean tacky roller 2:
a. Remove the sponge swab and the swab handle from the Everest
cleaning kit.
b. Insert the sponge swab into the unnotched end of the swab
handle, if necessary.
c. Apply isopropyl alcohol to the sponge swab.
d. Use the sponge swab to clean any dust or waxy residue from
tacky roller 2.
3. Reinstall tacky roller 2:
a. Hold the tacky roller by the end piece and insert the other end of
the tacky roller into the hole with the white plastic supporting
tray at the back of the printer enclosure.
b. Hook the end piece around the inside of the thumb screw and
position the end piece so it is flush with the center bracket.
c. Tighten the thumbscrew until the end piece is secure.
2004849_A
Tacky Roller 2
For more information visit rimage.com/support
15