Filter Maintenance; Cleaning The Filters - Rimage Professional 2450 Benutzerhandbuch

Filter Maintenance

17.1: Cleaning the Filters

Your filters should be cleaned with water when you can see that they have
accumulated a layer of dust. Please follow these steps to do so:
1. Remove the filters from the vents by squeezing the long edges of the
filter casings and pulling outward.
2. Remove the filter sponges from the filter casings.
3. Rinse both sides of each sponge under cold tap water until the water
runs through it clearly.
4. Gently ring out the water until no droplets are visible in the mesh of the
sponges, being cautious not to stretch out or tear the material.
5. Put the sponges back into the filter casing.
6. Reinstall the filters by again squeezing the long edges of the filter holder
until the filters are securely fixed to the case vents. See the image to the
right for correct placement.
Tip: If your filters become worn or damaged, contact Rimage
Support for replacements.
2004849_A
Filter Casing
Filter Sponge
For more information visit rimage.com/support
17