6.6.2. Removing the rear wheel
•
Turn off the Bosch eBike System.
•
Pull the belt tensioner back by hand so
that you can insert an Allen key in the
place shown to lock it.
•
Open the plug connection behind the E14
box by pulling both socket and plug apart.
•
If necessary, undo existing cable ties so
that you can remove the rear wheel.
Danger of cable / plug defects on Rohloff E14 due to incorrect operation!
→ Only pull the socket and plug, never the cable.
→ Pull the plug and socket apart in a straight line without twisting or ben-
ding them.
•
Open the quick release.
•
Pull the rear wheel out downwards.
•
Remove the belt from the rear pulley without
twisting it.
•
Slide the transport lock between the brake
pads.
6.6.3. Change tyre/tube
•
Unscrew the valve cap and large knurled nut from the valve.
•
Release the air by pressing on the valve pin in the middle of the valve.
•
Use tyre levers to remove the tyre from the rim on one side. If necessary, use
detergent and water to make the tyre easier to lift off.
•
Remove the tyre and inner tube and make the desired change.
•
Inflate the inner tube slightly and insert it into the tyre.
•
Observe the tyre's direction of travel as printed by the manufacturer, then in-
sert the valve through the valve hole in the rim and pull the tyre and inner tube
combination onto the rim from one side.
Maintenance
119