Long Ribbon Velocity; Global Midi Channel; Long Ribbon Midi Channel; Transpose - Korg RK-100S 2 Bedienungsanleitung

RK-100S 2 Owner's Manual
Cu.7 This curve produces a fairly steady effect with
little change for medium-strength playing.
Cu.8 This curve produces a fairly steady effect
with little change for medium-strength
playing (a flatter curve than 7).
127 All notes will sound at maximum velocity
(127). This setting mimics the behavior of
early analog synths.
Cu.7 and 8 produce little change for medium-
strength playing. However, these curves will
produce a great deal of change with softly played
notes, so they may be more difficult to control.
Choose the curve that is most appropriate for your
playing dynamics or for the effect you want to
obtain.
3. Press the SHIFT button to exit the shift function.

Long ribbon velocity

This allows you to specify the velocity when using the
long ribbon controller to play scales.
1. Hold down the SHIFT button and press the
favorites B button.
The velocity setting appears in
the display.
2. Use the OCTAVE +/- buttons or
the SOUND/FAVORITE BANK
lever to specify the velocity
setting.
The velocity setting range is 1–127.
If oFF is selected, no sound is produced when the
long ribbon controller is used.
3. Press the SHIFT button to exit the shift function.

Global MIDI channel

In order to exchange data with a connected external
MIDI device, you must set the RK-100S 2's Global MIDI
channel to match the MIDI channel of the external MIDI
device.
1. Hold down the SHIFT button and press the
favorites C button.
The number of the Global MIDI
channel appears in the display.
2. Use the OCTAVE +/- buttons or
the SOUND/FAVORITE BANK
lever to specify the Global MIDI
channel.
3. Press the SHIFT button to exit the shift function.
4. Set the MIDI channel of the connected external
MIDI device.
Note: For details on how to set the MIDI channel of the
external MIDI device, refer to the owner's manual of the
connected device.
16

Long ribbon MIDI channel

This allows you to specify the MIDI channel when using
the long ribbon controller to play.
Specify a setting when using a program with sound
generation set to Multi (Voice mode: Multi) or when the
external MIDI device that's connected to the MIDI OUT
jack is being played using the long ribbon controller,
instead of the keyboard.
When the setting is changed, sound from the
RK-100S 2 can no longer be produced with the long
ribbon controller.
1. Hold down the SHIFT button and press the
favorites D button.
The number of the long ribbon
MIDI channel appears in the
display.
2. Use the OCTAVE +/- buttons
or the SOUND/FAVORITE
BANK lever to specify the MIDI
channel.
GLb: The MIDI channel will match the global MIDI
channel (see "Global MIDI channel") .
r.01...r.16: 1ch..16ch
Tip: When using the long ribbon controller to control an
external MIDI device that's connected to the MIDI OUT
jack, specify the same MIDI channel that's specified on the
external MIDI device.
3. Press the SHIFT button to exit the shift function.
Note: When the arpeggiator is turned on, note messages
are transmitted from the MIDI OUT jack with the global
MIDI channel.

Transpose

This allows you to specify overall pitch in steps of
a semitone (100 cents). Use this when you want to
transpose to suit the song you are playing over a range of
one octave up or down.
1. Hold down the SHIFT button and press the
favorites E button.
The transpose setting appears in
the display.
2. Use the OCTAVE +/- buttons or
the SOUND/FAVORITE BANK
lever to specify the transpose
setting.
The transpose setting range is one octave up or
down (-12–12).
3. Press the SHIFT button to exit the shift function.