Trimming Operation; Product Features - SYMA X300 Gebrauchsanweisung

Trimming operation

Forward and backward trim control
1
Left/right side flight trim control
1
2

Product Features

1. Low-Voltage Protection:
Low battery
Over-Current Protection:
2.
3.Level Calibration Function:
Level calibration
2
When the four indicator lights at the bottom of drone
start flashing, it means that the drone's battery power is
low. At this time, please control the drone return.
When the drone encounters direct impact from a
foreign object, or is obstructed, or the blades are not
rotating, the drone will go into the over-current
protection mode.
If the drone automatically flies
forward/backward while hovering, press
in the left joystick and at the same time
push the right joystick backward/forward
slightly to fine tune the direction. Don't
release the left joystick until the drone is
flying in a stable state.
If the drone automatically flies towards
the left/right side while hovering, press in
the left joystick and at the same time
push the right joystick right/left slightly to
fine tune the direction. Don't release the
left joystick until the drone is flying in a
stable state.
Place the aircraft on a level surface
and move the left and right joysticks to
the lower right corner for
approximately 3 seconds. The
indicator will flash rapidly and then
stay constant to indicate that the
calibration process is complete.
-7-
English