Main Specifications - SYMA X300 Gebrauchsanweisung

Main Specifications

320mm
Drone's Length: 320mm
Drone's Height: 50mm
Battery : 3.7V 1500mAh lithium battery
Rectification Procedures
Problem
The drone
has no
response
The flight
response of
the drone is
not sensitive
The drone is
flying towards
its side in one
direction during
hovering
In the headless
state, it is biased
towards the front
direction
Fixed high
instability / up
and down
movement
50mm
Reason
1. The drone has entered into
low-voltage protection.
2. When the power of the remote
control is weak,the power light
indicator will blink.
1. The power of the remote control
is weak.
2. There is an interference with
the same frequency as that of
the remote control.
1. The drone is not calibrated
level to the ground.
1. Many collisions may cause
head drift.
1.The drone is not calibrated
level to the ground.
2.Unstable air pressure under
the severe weather condition.
3. Violent collision resulting in
data disorder of gyroscope.
320mm
Drone's Width : 320mm
Motor's Model : Ø8x16
Solution
1. Charge up the drone.
2. Change the batteries of
the remote control.
1. Change the batteries.
2. Change to a place where there
is no interference with the same
frequency.
1. Re-adjust the calibration until
the drone is level to the ground.
For further details,
1. Re-define the front direction.
For further details,
1.Re-adjust the calibration until
the drone is level to the ground.
For further details,
2. Avoid to fly under the severe
weather condition.
3. Make level adjustment again,
-14-
English