SYMA X300 Gebrauchsanweisung Seite 10

7. Headless Function:
①.Defining forward direction:
Front
Left Right
Back
②.Toggling between headless function and normal function:
Front
Left Right
Back
●Press on the power button of the remote control.
●Press the power button of the drone, and adjust the
specified direction of the drone's head under the
headless mode as the new forward direction.
●Push the left joystick (throttle) on the remote control
up to the farthest position and then pull down to the
farthest position. When the remote control issues a
long "beep" sound, it means the frequency and
defining forward direction functions are completed.
● After the drone is matched with the corresponding
frequency, the drone would be in normal pattern by
default. At this time the indicator light on the drone would
be in a state of on for a long time. After pressing in on
the right joystick of the remote control for 2 seconds, the
remote control would make a sound of "beep, beep,
beep" to show that it has entered into a state of headless
mode. Press in the right joystick for 2 seconds then a
long sound of "beep" would be heard to show an exit
status. (When under the state of headless mode, four
indicator lights on the drone flash slowly once every four
seconds).
● Under the headless mode, the operator does
Front
not need to differentiate the head position of the
Left Right
drone, and only needs to control the drone's
Back
direction front / back / left / right by using the
right joystick direction on the remote control.
-9-
English