Installation; Scan; Antenna Setting - SetOne TX-1200 Bedienungsanleitung

3. Installation

Please select the menu option "installation "(pin code: 0000 if requested). In this
menu you can work on your antenna setting and make further settings to your
satellite reception.
With the direction keys CH ▲ and CH▼ you can navigate them in the menu,
with the key "OK" you can select a menu option, and you can use the "EXIT
"or "MENU "key to reture to the menu.
The transitter data are presetted. Adjust these settings only, if you
know the exact values and know well with satellite transmission
technology.

3.1 Scan

In this menu option you can make simply scan by Satellite Scan, TP Scan, and
Blind Scan

3.2 Antenna setting

In this menu option you can simply set
your Receiver to the satellite as you
wished. The following parameters can be
edited: LNB type; Frequency; DiSEqC;
LNB power.
With the keys VOL◄ and VOL► you can
enter your desired values, then to confirm
with "OK" key thereby the values to be
saved.
Satellite
In the right column you can select a satellite from the pre-programmed ones
(There is only the receiptable satellites, to which your satellite is aligned)
LNB Type
Here you can select the LNB type which can be used by your receiver (standard:
Universal).
The usual standard settings for the respective used LNB type are deposited for
all further menu options.
17