Preparing For Use; Operation; Cleaning And Care - UNITED OFFICE 73527 Bedienungs- Und Sicherheitshinweise

Safety advice / Preparing for use / Operation / Cleaning and care
at all times. Never use the appliance when you
are distracted or don't feel well.

Preparing for use

Place the strip cut shredder onto a suitable con-
tainer.
Place the wide end of the appliance on the
edge of the container. Then pull the telescopic
arm out sufficiently to ensure that this also
4
sits securely on the edge of the container.
Insert the plug into a mains power socket.

Operation

Note: You can shred up to 5 sheets of DIN A4
paper (80 g / m 2 ) at the same time.
Note: Remove all paper clips or staples before
feeding the paper into the cutter opening
erwise the cutting mechanism may be damaged.
Switching the appliance into the Fwd
mode:
For continuous shredding set the switch
the 'Fwd' (forward) position.
Note: The appliance runs continuously. Insert the
paper from above and in portrait format into the
cutter opening .
2
Note: Be aware of the 2 minute operating time.
Switching the appliance into the Auto
mode:
For automatic shredding set the switch
the 'Auto' position. The motor starts automati-
cally when the paper is inserted and switches
itself off automatically if no further paper is in-
serted.
Note: Always insert smaller pieces of paper cen-
trally in the middle of the cutter opening
contact which starts the cutting process is located
there.
Clearing a material blockage:
Slide the switch into the 'Rev' position
1
(reverse) should the paper become jammed.
8 GB
Clear the paper feed of paper debris by
means of the 'Fwd' (forward) running.
Slide the switch into the 'Auto' position.
Reduce the amount of paper per feed to be
shredded and continue with the shredding
process.
Switching the appliance off:
When you have finished using the appliance,
always remove the plug from the mains power
socket.
Note regarding overheating of the
appliance:
If it overheats, the appliance switches off automati-
cally.
Remove the plug from the mains power socket.
Empty the container.
Allow the appliance to cool down.
. Oth- Replace the power plug in the socket.
2
Switch the appliance on by setting the switch
in the 'Auto' position.

Cleaning and care

1 to
DANGER TO LIFE FROM ELECTRIC
SHOCK! Always remove the power plug
before cleaning the appliance.
CAUTION! The cutting blades in the appli-
ance are very sharp! Injury hazard!
Under no circumstances should you use liquids
to or detergents, as these will damage the device.
1
Do not use solvents, petrol etc.
Clean the outside of the appliance only with a
soft, slightly moist cloth.
Remove the plug from the mains power socket.
Remove any remnants that may be present in the
. The cutter opening
2
a suitable object, such as a pair of tweezers.
or in the cutting blades with
2
1