Fault Messages; Ce Marking And Conformity - Schego TR2 Bedienungsanleitung

Fault messages

The following fault messages may be shown:
Fault N1
Fault N2
Fault N3
Fault N4
Fault N5
Disposal
Do not dispose of this product with regular household waste once it reaches the
end of its service life. This product must be submitted to a collection point for
recycling electrical and electronic waste.
The materials can be recycled according to their markings.
Please check your local services for information on the respective collection systems for
electrical and electronic waste. By reusing, recycling materials or otherwise recycling
end-of-life devices, you are making a major contribution to protecting your environment.

CE marking and conformity

The thermostat complies with the fundamental requirements and other applicable pro-
visions as laid out in Directives 2014/30/EU, 2014/35/EU and 2011/65/EU. The corre-
sponding declarations and documents are available from the manufacturer.
Short circuit detected in temperature sensor. Tem-
porary faults in sensor line.
No sensor connected.
The data fed by the sensor are faulty. Cable is lying on
interference field. When routing the cables, make
sure that they are kept separate from signal lines and
other wiring that produces interference, such as
mains power lines.
The sensor has been unexpectedly reset. Possible
faults: interference along cable, impaired plug con-
nector contact, impaired power socket contact.
Switching relay overheated.
Note: When a fault occurs, the thermostat will always
shut off the power socket.
Fault messages
35