Schego TR2 Bedienungsanleitung Seite 33

6. Confirm your changes by pressing 'Set'.
NOTE:
A menu item showing the symbol
box can have one of two settings:

: OFF

: ON
7. To exit setting mode, choose the menu item 'Exit' and press 'Set' to confirm.
NOTE:
When the thermostat is in setting mode and no button is pressed for more than ten
seconds, the thermostat automatically exits setting mode and reverts to display mode.
Any changes made in setting mode will be saved when this happens.
How to start the connected appliance and thermostat
1. Set the desired target temperature and switching accuracy ('T set menu item' on
page 29).
2. Plug the power plug of the appliance you are connecting into the power socket in the
thermostat and switch on the connected appliance if it has a separate power switch.
How to shut down your thermostat
1. Make sure that the connected appliance has been switched off if it has a separate
power switch.
2. Unplug the power plug of the connected appliance from the thermostat's power
socket.
3. Remove the sensor from the surface onto which it is attached.
4. Pull the thermostat out of the power socket.
- You have shut down your thermostat.
How to start the connected appliance and thermostat
or is what is known as a checkbox. A check-
33