Technical Data; Rating Plate - Zanussi ZEV8646XBA Benutzerinformation

Problem
The sensor fields become hot.
comes on.
and a number come on.
You can hear a constant beep
noise.
comes on.
8.2 If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an
Authorised Service Centre. Give the data
from the rating plate. Give also three digit
letter code for the glass ceramic (it is in the
corner of the glass surface) and an error

9. TECHNICAL DATA

9.1 Rating plate

Model ZEV8646XBA
Typ 60 HBD 47 AO
Ser.Nr. .................
ZANUSSI
9.2 Cooking zones specification
Cooking zone
Left front
Left rear
Right front
Right rear
40 ENGLISH
Possible cause
The cookware is too large or you put
it too near to the controls.
Child Safety Device or Lock oper‐
ates.
There is an error in the hob.
The electrical connection is incor‐
rect.
The second phase of the power sup‐
ply is missing.
Nominal Power (Max heat setting)
[W]
750 / 2200
1200
1200
1500 / 2400
Remedy
Put large cookware on the rear zones,
if possible.
Refer to "Daily use".
Deactivate the hob and activate it
again after 30 seconds. If
on again, disconnect the hob from the
electrical supply. After 30 seconds,
connect the hob again. If the problem
continues, speak to an Authorised
Service Centre.
Disconnect the hob from the electrical
supply. Ask a qualified electrician to
check the installation.
Check if the hob is correctly connected
to the electrical supply. Remove the
fuse, wait one minute, and insert the
fuse again.
message that comes on. Make sure, you
operated the hob correctly. If not the
servicing by a service technician or dealer
will not be free of charge, also during the
warranty period. The instructions about the
Service Centre and conditions of guarantee
are in the guarantee booklet.
PNC 949 595 525 04
220 - 240 V 50 - 60 Hz
Made in Germany
7.0 kW
Cooking zone diameter [mm]
120 / 210
145
145
170 / 265
comes