Technical Data; Rating Plate - Zanussi ZEI6840FBA Benutzerinformation

Problem
and a number come on.
You can hear a constant beep
noise.
8.2 If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an
Authorised Service Centre. Give the data
from the rating plate. Give also three digit
letter code for the glass ceramic (it is in the
corner of the glass surface) and an error

9. TECHNICAL DATA

9.1 Rating plate

Model ZEI6840FBA
Typ 60 GAP D5 AU
Induction 6.6 kW
Ser.Nr. .................
ZANUSSI
9.2 Cooking zones specification
Cooking zone Nominal power
(maximum heat
setting) [W]
Left front 2300
Left rear 1200
Right front 1200
Right rear 1800
The power of the cooking zones can be
different in some small range from the data in
the table. It changes with the material and
dimensions of the cookware.
84 ENGLISH
Possible cause
The diameter of the bottom of the
cookware is too small for the zone.
There is an error in the hob.
The electrical connection is incor‐
rect.
message that comes on. Make sure, you
operated the hob correctly. If not the
servicing by a service technician or dealer
will not be free of charge, also during the
warranty period. The instructions about the
Service Centre and conditions of guarantee
are in the guarantee booklet.
PNC 949 492 073 02
220 - 240 V 50 - 60 Hz
Made in Romania
6.6 kW
PowerBoost [W]
2800
-
1800
-
For optimal cooking results use cookware no
larger than the diameter in the table.
Remedy
Use cookware with correct dimen‐
sions. Refer to "Technical data".
Deactivate the hob and activate it
again after 30 seconds. If
on again, disconnect the hob from the
electrical supply. After 30 seconds,
connect the hob again. If the problem
continues, speak to an Authorised
Service Centre.
Disconnect the hob from the electrical
supply. Ask a qualified electrician to
check the installation.
PowerBoost Cookware diame‐
maximum dura‐ ter [mm]
tion [min]
10 180 - 210
- 125 - 145
4 125 - 145
- 145 - 180
comes