Technical Data; Rating Plate - Zanussi ZEI6840FBA Benutzerinformation

Problem
The sensor fields become hot.
comes on.
comes on.
comes on.
and a number come on.
You can hear a constant beep
noise.
IF YOU CANNOT FIND A SOLUTION...
If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service
Centre. Give the data from the rating plate. Give
also three digit letter code for the glass ceramic (it
is in the corner of the glass surface) and an error
message that comes on. Make sure, you operated

TECHNICAL DATA

RATING PLATE

Model ZEI6840FBA
Typ 60 GAP D5 AU
Induction 6.6 kW
Ser.Nr. .................
ZANUSSI
Possible cause
The cookware is too large or
you put it too near to the con-
trols.
Automatic Switch Off oper-
ates.
Child Safety Device or Lock
operates.
There is no cookware on the
zone.
The cookware is unsuitable.
The diameter of the bottom of
the cookware is too small for
the zone.
There is an error in the hob.
The electrical connection is in-
correct.
the hob correctly. If not the servicing by a service
technician or dealer will not be free of charge, also
during the warranty period. The instructions about
the Service Centre and conditions of guarantee are
in the guarantee booklet.
PNC 949 492 073 02
220 - 240 V 50 - 60 Hz
Made in Romania
6.6 kW
Remedy
Put large cookware on the rear
zones if possible.
Deactivate the hob and acti-
vate it again.
Refer to "Daily use".
Put cookware on the zone.
Use suitable cookware. Refer
to "Hints and tips".
Use cookware with correct di-
mensions. Refer to "Technical
data".
Deactivate the hob and acti-
vate it again after 30 seconds.
If comes on again, discon-
nect the hob from the electrical
supply. After 30 seconds, con-
nect the hob again. If the prob-
lem continues, speak to an Au-
thorised Service Centre.
Disconnect the hob from the
electrical supply. Ask a quali-
fied electrician to check the in-
stallation.
27