SATA AE1022H Bedienungsanleitung Seite 74

Fault phenomenon
Large clearance of sliding
arm
Cylinder gas blow-by
Cylinder air leakage
Five-way valve air leakage
Five-way valve gas blow-by
Oil atomizer air leakage
No oil drop from oil atomizer
Air leakage from rotary
distribution valve
Gas blow-by from rotary
distribution valve
Failure in closing opened
claw/jittering
The belt is liable to damage
The positive and negative
rotation of switch is opposite.
Loud noise produced by
reduction gearbox
74
AE1022H/AE1022H-3
Fault causes
Wrong position of upper and lower roller bearing and
side top thread
Damage of piston seal ring/gas pipe joint
O-ring damage/piston rod scratch/gas pipe joint
damage
O-ring damage/gas pipe joint damage
O-ring damage
O-ring damage/foreign matters/gas pipe joint damage
Too little amount of oil drop adjusted/no oil
O-ring damage/gas pipe joint damage
O-ring damage
Foreign matters/no lubricating oil/claw deformation
Too tight belt/out-of-level between the belt pulley and
the belt disk/overuse
Wrong wiring
Loose screw/no lubricating oil/bearing damage
中文
EN DE RU KO
Troubleshooting methods
Adjust position
Replace
Replace
Replace
Replace
Replacement/removal of foreign matters
Increase the amount of oil drop/refueling
Replace
Replace
Clean up foreign matters/lubricate/
replace
Adjust position and level/replace
Reconnect/replace
Lock screw/lubricate/replace
PT JA ES