SATA AE1022H Bedienungsanleitung Seite 61

2.7 Power source connection
Before energizing, check whether the network voltage is consistent with the voltage value indicated on the equipment label.
Very important: The equipment is connected with the electrical system, which shall be equipped with circuit fuse, good grounding shall
conform to the local national standards, and leakage protection devices shall be provided for the equipment when necessary to ensure
safe operation of the equipment.
2.8 Air source connection
1) Step on the clamping pedal to ensure that the crankset claw will not suddenly open.
2) Connect the air source to the oil-water separator with a quick connector. And adjust the pressure gauge to display air pressure.
3) Connect the inflation gauge to the air source with a pipeline, and press the handle to confirm that the inflation function is normal.
2.9 Complete machine test
1) Step on the rotating pedal to turn the crankset clockwise. Jack up the pedal to turn the crankset counterclockwise.
2) Step on the clamping pedal to open the four crankset claw, and step on the pedal again to close the claw.
3) Step on the tire pressing clamping pedal to put the tire leaning shovel into working state through the tire shovel, and step on the pedal
again to return the tire leaning shovel to the original position.
4) Step on the reversing arm pedal to tilt the column backward in U shape; step on the pedal again to return the column to the working
position.
5) Press the handle button (Y position) to lock the tire dismounting arm and push-pull arm; return the handle button (Z position) to unlock
the tire dismounting arm and push-pull arm.
6) Check whether there is 1 oil drop dripping from the oil-water separator after stepping on the pedal for 3-4 times. If not, use screws for
adjustment.
Note: For 380 V equipment models, if the rotation direction of the crankset is different from the above direction, replace the two phase
lines on the 3-phase wiring terminal.
AE1022H/AE1022H-3
中文
EN DE RU KO PT JA ES
61