Kübler CODIX 555 Bedienungsanleitung Seite 52

5 5 . . 5 5 A A l l a a r r m m s s / / A A l l a a r r m m o o u u t t p p u u t t s s
One, two or no alarms can be active.
When exceeding
Alarm 1
Alarm 2
5 5 . . 5 5 . . 1 1 A A l l a a r r m m 1 1 / / A A l l a a r r m m o o u u t t p p u u t t 1 1
5 5 . . 5 5 . . 1 1 . . 1 1 A A l l a a r r m m 1 1 o o f f f f / / o o n n
Menu <–> Selection
press the key to accept the selection
5 5 . . 5 5 . . 1 1 . . 2 2 A A s s s s i i g g n n A A l l a a r r m m 1 1
Menu <–> Selection
press the key to accept the selection
5 5 . . 5 5 . . 1 1 . . 3 3 M M o o d d e e f f o o r r A A l l a a r r m m o o u u t t p p u u t t 1 1
Menu <–> Selection
press the key to accept the selection
Page 20
Signal on
Output 1
Outout 2
Example: on
➱
Alarm 1 not active
Alarm 1 active
Assignment
Totalizer
instantaneous value
Latch mode, Latch signal reset at output 1
➱
Chapter 5.5.1.5
Auto mode
Alarm a: threshold exceeded
b: below threshold
O O u u t t p p u u t t m m o o d d e e " " A A u u t t o o " " : : automatic resetting of output when the
signal falls below threshold, signal set to 0, LED extinguished.
O O u u t t p p u u t t m m o o d d e e " " L L a a t t c c h h " " : : Manual and/or electrical resetting
of signal and LED
LED display
on
on
Chapter 5.5.2 23
The limit value can be assigned either to
the totalizer value or the current
measured value.
22
www.kuebler.com