Proper Use; Technical Data; Before Starting The Equipment - EINHELL GC-HH 18/45 Li T Originalbetriebsanleitung

3. Proper use

This cordless pole hedge trimmer is suitable for
cutting hedges, bushes and shrubs. Caution! Do
not use this equipment to cut grass.
The equipment is to be used only for its prescri-
bed purpose. Any other use is deemed to be a
case of misuse. The user / operator and not the
manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

Operating voltage: ...................................18V DC
Cutter bar length: ................................... 450 mm
Max. cutting length: ................................ 410 mm
Tooth spacing: .......................................... 18 mm
Cuts/min: ..................................................... 1400
Caution!
The equipment is supplied without batteries and
without a charger and is allowed to be used only
with the lithium-ion batteries of the Power-X-
Change series!
The lithium-ion batteries of the Power-X-Change
series are allowed to be charged only with the
Power-X charger.
Danger!
Sound and vibration
Sound and vibration values were measured in
accordance with ISO 22868.
Sound pressure level L
Uncertainty K ............................................. 3 dB
pA
Measured sound power level L
Uncertainty K ............................................ 3 dB
WA
Guaranteed sound power level L
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
Anl_GC-HH_18-45_Li_T_SPK9.indb 19
.................... 82.8 dB(A)
pA
...... 91.1 dB(A)
WA
...... 102 dB(A)
WA
- 19 -
GB
Total vibration values (vector sum of three direc-
tions) determined in accordance with ISO 22867.
Handle under load
Handle (front)
Vibration emission value ah = 2.774 m/s
Uncertainty K = 1.5 m/s
Handle (rear)
Vibration emission value ah = 2.008 m/s
Uncertainty K = 1.5 m/s
The stated vibration emission levels and stated
noise emission values were measured in ac-
cordance with a set of standardized criteria and
can be used to compare one power tool with
another.
The stated vibration emission levels and stated
noise emission values can also be used to make
an initial assessment of exposure.
Warning:
The vibration and noise emission levels may vary
from the level specifi ed during actual use, depen-
ding on the way in which the power tool is used,
especially the type of workpiece it is used for.
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
•
Wear protective gloves.

5. Before starting the equipment

The equipment is supplied without batteries and
without a charger and is allowed to be used only
with the lithium-ion batteries of the Power-X-
Change series!
Caution! Do not fi t the battery until the equipment
has been fully assembled and all the settings
have been actuated. Always wear protective
gloves when working on the equipment to protect
yourself against injury.
2
2
2
2
05.10.2020 14:07:08