Troubleshooting Table - Blaupunkt TravelPilot 700 Bedienungs- Und Einbauanleitung

Troubleshooting table

Problem
The device does not work or
does not work correctly.
The display remains dark if I
switch on the device.
The battery is empty, even
though I did not use the device
for some time.
The device does not respond
when I touch the buttons.
The device does not output any
turn-by-turn directions via voice
output.
Cause
The operating system is over-
loaded.
The display may temporarily
loose its contrast after long and
heavy exposure to the sun and
high temperatures.
At very high temperatures, the
device switches off to protect
against overheating.
The battery is not suffi ciently
charged.
The device continues to use a
small amount of energy if it is
switched off. Hence, the bat-
tery could be discharged after
a few days.
During short driving times,
the battery is not completely
charged.
The operating system is over-
loaded.
The voice instructions are deac-
tivated.
The volume of the voice instruc-
tions is too low.
Troubleshooting table
Measure
Perform a reset (ch. "Switching
on/off")
Reset the factory settings (ex-
tended instructions on the CD/
DVD, ch. "Settings"). All per-
sonal settings will be deleted!
Reinstall the navigation software
using the enclosed CD/DVD.
Place the device in the shade for
approximately 10 minutes and
switch it on again.
Fully charge the battery. (Ch.
"Charging the battery")
To obtain battery operation
of up to 3 hours in navigation
mode, completely charge the
battery.
Always operate the device in the
vehicle together with the charg-
er cable via the cigarette lighter.
Perform a reset (ch. "Switching
on/off")
Activate the voice output in the
map/navigation settings.
Increase the volume during a
voice output.
47