Switching On/Off; Setting The Language; Installation In The Vehicle; Attaching The Suction Cup Holder - Blaupunkt TravelPilot 700 Bedienungs- Und Einbauanleitung

• The device is supplied by an external
power source.
• The device is supplied by its internal
battery. The charge state of the bat-
tery is suffi cient.
• The device is supplied by its internal
battery. The charge state of the bat-
tery is low.
If the charge state of the battery becomes weak,
the navigation device warns you about it.
u
Connect the battery charger or the charger
cable for the cigarette lighter to the charging
socket.
Note:
The battery is equipped with a protection
against overheating from excessive current
fl ow. The protection prevents charging the
battery starting at an ambient temperature
above 45 °C.

Switching on/off

u
Press and hold the On/Off switch for longer
than 1 second (On) or 3 seconds (Off).
If you switch off the device, it is initially
switched to idle state and remains operation-
al. All functions will be completely switched
off after 2 hours.
To perform a reset (restart):
u
Press and hold the On/Off switch for longer
than 14 seconds.
Initial startup | Installation in the vehicle

Setting the language

The device uses English as the standard language
for the menus, voice output and speech input.
When you switch on the device for the fi rst time,
a dialogue menu appears in which you can select
another language:
u
Select your preferred language in the dia-
logue menu.
u
Follow the instructions on the display.
The language is loaded and the main menu is
displayed.

Installation in the vehicle

For temporary installation in a vehicle, the navi-
gation device features a holder to attach it to the
windshield.
DANGER!
The installation at an unsuitable loca-
tion can cause injuries
Install the navigation device so that it does not
block your view and does not distract from the
traffi c.
Do not install the device in the airbag deployment
area.
Ensure that the device does not pose a threat to
passengers in the vehicle in case of emergency
braking.
Check the fi rm installation of the bracket at regular
intervals. The bracket can loosen due to changes
in the ambient temperature.

Attaching the suction cup holder

u
Locate a suitable place inside the vehicle for
the installation.
To ensure a perfect hold, the glass must be
free of dust and oil. If necessary, clean the
glass using a lens cleaning tissue.
u
Press the suction cup of the holder against
the windshield.
u
Push the lever on the support towards the
glass.
31