Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4.5.1 Programming unit Standard
Install the unit according to the attached circuit diagram (paragraph 4.1). Make sure that the colours of the installation
cables are identical with the colours of the motor cable. Connect with the mains only after completing the installation!
Adjusting the stop positions:
1.
Press button E
for at least 6 seconds. The motor switches into adjustment mode.
2
A short stop after the start indicates the adjustment mode!
2.
Drive to the bottom end position (projection position) by pressing button
3.
Press button E
for at least 3 seconds, the bottom end position (projection position) is set.
2
4.
Drive carefully to top end position by pressing button
crash against the ceiling construction!
5.
Press button E
for at least 3 seconds. Top end position (home position) is set.
2
6.
After adjusting the unit you should make a test drive. If the ceiling lift stops at the programmed end positions, the
adjustment has been carried out correctly.
4.5.2 Electronic programming unit
Install the unit as shown in the circuit diagram. For adjusting the stop positions follow the instructions in the user manual
of the unit.
4.6 Adjusting the ceiling cover plate
When the lift is in its upper position the cover plate should be level with the surface of the false ceiling. One method is to
fasten the screws of the extension elements on the cover plate only slightly, to adjust the upper stop position, to move the
lift upward into this position and to press the ceiling cover plate manually against the surface of the false ceiling. Afterwards
lower the lift again and tighten the screws. Also the screw
4.7 Mains connection of the control unit
The lift can be controlled via:
1.
Switch/button up/down
2.
Key switch
3.
Radio remote control
4.
IR remote control
5.
2 relais contacts of a media control
system and a motor control unit
After adjusting the stop positions you must disconnect the external programming unit and connect the wiring of the motor
according to the following circuit diagram.
Circuit diagram installation of switches/buttons
Mains
Ceiling lift
26
b
5944000002
5944000001
5699000020
5699000021
5699000022
Projector
switch
Switch for
rope control
blue
black
brown
yellow/green
Projector
Power socket
ceiling lift
.
1
(home position, the lift is up). Attention: Do not let the lift
1
on the projector holder
must be secured with a spanner.
8
Splitter
blue
Switch
button
black
brown
yellow/green
socket
Mains
Werbung
Kapitel
Inhaltsverzeichnis
