Choosing The Installation Place; Mounting On Real Ceiling; Stencil For Drilling - Kindermann Deckenlift compact Montageanleitung

If the projector lens is located on its broad side, the ceiling lift can be mounted in a 90° angle.
Maximum space for projector below the cross bar: 47 x 56 cm.
Minimum installation depth: 13 cm + projector height (Compact 80).
Minimum installation depth: 15 cm + projector height (Compact 120).

3.3 Choosing the installation place

Bevore opening the ceiling the proper installation place must be tested, ideally with the help of a test projection, as lens
tolerances or misprints in picture size charts can happen.
When deciding about the proper position of the lift, take into account that the front bar of the lift lies half way between the
zoom range of the projector and the lens is directed towards the centre axis of the screen in a right angle. There should be a
safety distance of 0.5 m between the installation place and any hot water pipes.

3.4 Mounting on real ceiling

Remove sufficient parts of the false ceiling around the installation place. Fix the supplied stencil for drilling with adhesive
tape to the proper place, drill the holes 1 to 6 as indicated, remove the stencil, premount screws 1 to 4 but do not tighten
them.
Take the ceiling lift out of its packaging, hang up the upper frame at the screws 1 to 4 and make sure that the lift can't drop.
Now insert the other screws and tighten them all (1 to 6). Make sure that the lift is in horizontal position after mounting.

3.4.1 Stencil for drilling

659,5
524,8
1 5
4 6
Ceiling cutout 600
256,3
12,5
2
3
21