Cleaning And Maintenance - Concept VP 807 Serie Bedienungsanleitung

If the dust collection bag fill indicator is still red after the bag has been replaced, this may be due to several
causes:
- some of the air passages (hoses, telescopic tube, suction inlet, brush adapter, or other adapters) are
obstructed;
- the motor filter is dirty;
- the air outlet filter is dirty.
Check for each of the possible causes above and eliminate the problem before you start vacuuming. If the
cause of the problem cannot be identified, hand over the product to the nearest service centre. Never use the
vacuum cleaner if the bag level indicator is completely red during operation. The motor could be damaged
irreparably

CLEANING AND MAINTENANCE

You may clean the accessories and the appliance with a wet cloth. Never immerse the appliance in water!
Do not use any aggressive substances for cleaning, such as solvents or abrasives!
REPLACING THE DUST COLLECTION BAG
1. Unplug the product from the mains. Disconnect the hose from the suction inlet and open the appliance
cover.
2. Push the flap on the dust retention bag holder; remove the used dust
retention bag (Fig. 3). Dispose of a paper or SMS dust collection bag. Be
careful not to tear the bag when handling. If the bag is made of fabric,
empty it and close it carefully – it can be used repeatedly.
3. Insert a new or empty dust retention bag by fitting the plate in the bag
holder. The bag opening must be aligned with the hose hole in the ap-
pliance cover.
4. Never use the vacuum cleaner without the dust bag installed! If you
forget to insert the dust retention bag or you insert it incorrectly, the
appliance's motor may become damaged.
5. Close the cover. Press until you hear a click.
REPLACING FILTERS
• The filters should be cleaned or replaced when they are visibly dirty, or
if the appliance's suction power is reduced. Always check the filters after
using the appliance.
• In order to avoid damage to the appliance, do not use it with incorrectly
installed filters.
• Before replacing the filters, disconnect the appliance from the electrical
socket.
• You can buy suitable types of filters from your dealer, or you can order
them from the manufacturer.
CLEANING AND REPLACEMENT OF THE MOTOR FILTER
1. Disconnect the flexible hose and open the appliance cover.
2. Pull the dust collection bag out of its holder so that you can access the
motor filter more easily.
VP 807x
EN
Fig. 3
Fig 4
Fig 5
55