Front Panel Ir Learning; Relay Control Settings - Kindermann HDMI Control Basic 4K60 Inbetriebnahme- Und Bedienungsanleitung

7.3.5 Front panel IR learning

Besides confi guring IR control by RS232 commands those can be learned from IR remote directly by using
the SET button on the front panel.
Please proceed according the steps below to learn IR commands from IR remote:
Step 1:
• Press SET to choose DISPLAY ON or DISPLAY OFF command to be set.
• DISPLAY ON LED: Flashing indicates that DISPLAY ON mode is selected.
• DISPLAY OFF LED: Flashing indicates that DISPLAY OFF mode is selected.
Step 2:
Point the IR remote to the SENSOR and press the respective button on the IR remote.
Step 3:
The DISPLAY ON or DISPLAY OFF LED will stop fl ashing and remain lit to indicate that IR command has
been learnt.
Step 4:
Press and hold the SET button for 5 seconds to learn user-defi ned IR command. Both DISPLAY ON and
DISPLAY OFF LEDs are fl ashing. Repeat step 2, both LEDs will stop fl ashing and remain lit to indicate that
IR command has been learnt.
Step 5:
The IR learning mode will self-terminate after 10 seconds of inactivity. Both LEDs will expire.

7.3.6 Relay control settings

Command
RELAY1COT:[XXX].
RELAY2COT:[XXX].
GRELAY1COT.
GRELAY2COT.
Function
Set the Relay 1 dwell time to XXX (default 10s =
010, range of 3 to 180s).
Set the Relay 2 dwell time to XXX (default 10s =
010, range of 3 to 180s).
Report Relay 1 dwell time.
Report Relay 1 dwell time.
Feedback/Explanation/Example
RELAY1COT:010.
Set RELAY 1 dwell time to 10S.
RELAY2COT:010.
Set RELAY 2 dwell time to 10S.
RELAY 1 TIME DELAY TIME 10S!
RELAY 2 TIME DELAY TIME 10S!
32